Sterling – SF Series Fiberglass Cooling Towers

 

 

 

 

Sterling SF Series Cooling Towers

The SF Series Cooling Towers offer unparalleled corrosion resistance, energy efficiency, and performance. For cooling requirements at 85°F (29.4°C) and above, water consumption may be reduced by 98.5% through the use of cooling towers to remove process heat. Sterling Cooling Tower Systems are used wherever a reduction in water usage, water costs, and/or control of mineral precipitation associated with cooling towers is desired.

 

 

 

 

 

 

 

 

 

 

 

  • High efficiency induced-draft design
  • Balancing valve and pressure gauge
  • Factory-tuned fan blade pitch
  • PVC fill and Drift eliminators with ultraviolet (UV) protection
  • Totally-enclosed non-ventilated TENV energy-efficient fan motor
  • Vertical air discharge
  • Large inspection/access door
  • Anti-clog ABS nozzle(s)
  • Stainless steel hardware
  • Bottom outlet (requires a 24” [61 cm] – minimum support base under the tower)
  • Lightweight non-corrosive fiberglass shell with fiberglass side seams
  • Exterior gel coat/UV inhibitor
  • 2 year warranty on parts
  • 1 year on fan motors
  • 1 year warranty on labor (North America only)
  • 10 year shell warranty
  • 460/3/60 or 230/3/60 starter package, including starter, on/off switch, thermostat, and well (consult factory for 208V or 575V)
  • Basin reservoir, to be used where the basin of the tower serves as a reservoir. It is not necessary to purchase this package where an inside reservoir is used. The parts consist of a 0.75” automatic float valve, water outlet basket strainer, and overflow connection (Not recommended for bottom outlet towers).
  • Heater, used with basin reservoir option to guard against freeze-up when system is shut down. Includes heater and low water heater shut off
  • Factory startup, including checking motors, flow, adjusting nozzles. Towers must be installed and connected, including all piping and electrical hookups before Sterling arrives on site.
  • Access ladder, meets OSHA requirements (shipped loose for field installation)
  • Side outlet configuration available at no charge